Surrey Hills, VIC Australia. Spare Part Kit of 4 Sensors TPMS Sensor for TP-10 & TP-09 Tyre Pressure Monitor Systems PSI Bar TP-10S-4. This premium sensor kit can be added to TP-09 and TP-10. With new IP ratings, Masten’s rearview cameras and tyre sensors are even more advantageous in environments requiring a high degree of protection from dust, submersion, and high-pressure, high-temperature spray-down. This level of protection is essential in many food & beverage, pharmaceutical, and petrochemical markets but also applies to off-road activities namely river crossing. Operational Temperature: -40 to 80°C. Storage Temperature: -40 to 85°C. Pressure Range: 0 to 8BAR, 0116PSI. Pressure Accuracy: ±0.1BAR, ±1.5PSI. Transmission Frequency: 433.92MHz. Battery life: 2 years(CR1632, -40 to 80°C). Size: 21mm(diameter) x 21mm(height). If the sensors have not been moved for 1 hour or more they will be in sleep mode. After around 5 seconds of movement, the sensors will’wake’ up and start sending the tyre information data (pressure/temperature) every 6 seconds to the monitor. Comes included in the box – also available upon request. Will this system work with my In-Dash Car DVD? If your current system has an RCA camera input, and a trigger line input (used for sending power from the reverse lamp to the stereo), it will work. What are Tyre Pressure Monitor Systems? Passenger vehicles in the 1980s and today is a mandatory feature in the United States. Benefits of a Masten TPMS? The dynamic behavior of a pneumatic tire is closely connected to its inflation pressure. Extreme under-inflation can even lead to thermal and mechanical overload caused by overheating and subsequently, sudden destruction of the tire itself. Additionally, fuel efficiency and tire wear are severely affected by underinflation. Tires do not only leak air if punctured, they also leak air naturally, and over a year, even a typical new, properly mounted tire can lose from 20 to 60 kPa (3 to 9 psi), roughly 10% or even more of its initial pressure. The significant advantages of TPMS are summarized as follows. Fuel savings: According to the GITI, for every 10% of under-inflation on each tire on a vehicle, a 1% reduction in fuel economy will occur. In the United States alone, the Department of Transportation estimates that under-inflated tires waste 2 billion US gallons 7,600,000 m. Of fuel each year. Extended tire life: Under-inflated tires are the #1 cause of tire failure and contribute to tire disintegration, heat buildup, ply separation and sidewall/casing breakdowns. Further, a difference of 10 lbs. In pressure on a set of duals literally drags the lower-pressured tire 13 feet per mile. Moreover, running a tire even briefly on inadequate pressure breaks down the casing and prevents the ability to retread. It is important to note that not all sudden tire failures are caused by underinflation. Structural damages caused, for example, by hitting sharp curbs or potholes, can also lead to sudden tire failures, even a certain time after the damaging incident. These cannot be proactively detected by any TPMS. Decreased downtime and maintenance: Under-inflated tires lead to costly hours of downtime and maintenance. Improved safety: Under-inflated tires lead to tread separation and tire failure, resulting in 40,000 accidents, 33,000 injuries and over 650 deaths per year. Environmental efficiency: Under-inflated tires, as estimated by the Department of Transportation, release over 57.5 billion pounds of unnecessary carbon-monoxide pollutants into the atmosphere each year in the United States alone. If we anticipate a longer lead time, it will be noted in the item description or you will be advised before we dispatch your order. Required by your country for importing consumer goods. We do not collect this beforehand, and can’t give you an estimate of the cost, because it varies widely around the world. We will be happy to remove the signature requirement on request; please contact our team before purchasing for details on what you require. Please note that, in this case, you will be accepting responsibility if anything were to happen to the package. We will take all the required precautions to pack your item well to avoid any incidental damages along the way. Today, there are over 15 staff members across 4 countries focussing on Engineering, Support, Marketing, Accounts and Sales. Drop by and say hello. Our opening hours are Monday to Friday however, exceptions may be made to meet you there on a weekend. Since 2009 Masten Engineers have been at the forefront of vehicle electronics for both OEM and Aftermarket. We maintain critical spare parts so in most occasions, parts are on hand and ready to solve your issues within a timely period. If we don’t have the part in stock, in most cases we can get it in for you despite the product’s age. If you have any questions please don’t hesitate to get in touch with our Support team who are here to help. We don’t take ourselves too seriously; until it comes to quality! We’re ultra-selective about the electronics, materials, manufacturing process, quality control and finishes of every product. Put simply, we only sell the best.
