Quality Products / Backed Locally. Product Support That Makes Sense. TPMS Tire Pressure Monitor System 8 External Cap 22 Sensors DVD Video Car. Monitor up to 22 Sensors on a Car Monitor. The Masten TP-10-8 TPMS Tyre Pressure Monitor System with 4 High-Quality External Cap-Style Sensors specifically designed for Camera Monitors and In-Dash Navigation/Multimedia Systems with a Reverse Trigger wire. IMPORTANT – This Listing DOES NOT include a stereo. It includes the following parts. Universal TPMS Module x 1. Premium External Cap Sensors x 8. Installation wiring x 1 set. Manual Switch Display Controller x 1. Power the camera (not included) from the reverse light. This is the only power required from the reverse light. DO NOT connect power of the reverse light to the TPMS or Car Radio Trigger wire. Power up the TPMS to 12V power and earth it. Connect the Positive trigger wire (white) of the TPMS to the Camera trigger wire on the car radio. Plug the RCA from the TPMS Module into the Camera RCA input on the car radio. TPMS for existing monitor. With Premium DIY Cap Sensors and Replacement Battery. The Masten TP-10 TPMS Tyre Pressure Monitor System is specifically designed for Camera Monitors and In-Dash Navigation/Multimedia Systems with a Reverse Trigger wire. The TPMS module simply sits inline between your reverse camera and monitor. This means that your reverse camera will operate normally however, the Tyre data can be viewed manually on demand by using the button, or automatically if there is a critical problem with the pressure or temperature of your tyres. Wiring Help: The TPMS has 4 wires. The red goes to ACC+ (12V), the black to Ground, the reversing trigger (positive) to the monitor trigger wire (for example BACK, Reverse etc), the reversing trigger (GND) should not connect to anything. After adding this TPMS module, you no need power from the reverse light of your vehicle. Cut this power completely. Pressure Range: 0116PSI (08 BAR). In-Dash Navigation System module specifically designed for In Dash A/V Monitor Displays. Monitor up to 22 Sensors. Monitor the pressure/temperature of four wheels at the touch of a button through your in dash A/V monitor. Your existing reverse camera can be connected to the Masten TPMS control module allowing for dual connection through the one input. Just connect the module into your Video or Camera input. If you don’t have a camera input, this TPMS module will allow you to add a reverse camera. TPMS information screen will automatically appear if a tyre problem is detected. The multi colour interface allows you to easily identify problem tyres in red for fast evaluation. Wireless multi-function power button can be mounted anywhere for drivers convenience. User programmable high and low pressure range. High quality alloy valves. 2-year battery life – easily replaceable. User friendly programming functions. Reliable and easy to install. Directly displays tire data on the vehicle display. Selectable pressure units: BAR or PSI. Selectable temperature units: °C or 0F. Configurable high / low pressure alert setting. Configurable high temperature alert setting. Selectable trailer ID and tractor ID. Enlargeable signal transmission in case of long distance from sensors to the receiver. Several ways for sensor coding. TPMS hand-held tool coding available. This will only work with 9-12V camera output. If you are connecting a genuine camera they can be 5-6V and will not work without some amplification. Wireless Range: 7 metres (any more and you need our repeater – TP-09REP). Remote Control: CR2025 (3V). Sensors: Please check under the cap for accurate info. Optional Accessory – Masten Range Extender. How can the alarm for low pressure be switched off? You can press the remote about 2 seconds to cancel the alarm sound, but the TP-09/TP-10 App alert data will still flash till the problems is solved. Will this system work with my In Dash Car DVD? If your current system has an RCA camera input, and a trigger line input (used for sending power from the reverse lamp to the stereo), it will work. What are Tyre Pressure Monitor Systems? Passenger vehicles in the 1980s and today is a mandatory feature in the United States. Benefits of a Masten TPMS? The dynamic behavior of a pneumatic tire is closely connected to its inflation pressure. Extreme under-inflation can even lead to thermal and mechanical overload caused by overheating and subsequent, sudden destruction of the tire itself. Additionally, fuel efficiency and tire wear are severely affected by under-inflation. Tires do not only leak air if punctured, they also leak air naturally, and over a year, even a typical new, properly mounted tire can lose from 20 to 60 kPa. 3 to 9 psi. , roughly 10% or even more of its initial pressure. The significant advantages of TPMS are summarized as follows. Fuel savings: According to the GITI, for every 10% of under-inflation on each tire on a vehicle, a 1% reduction in fuel economy will occur. In the United States alone, the Department of Transportation estimates that under inflated tires waste 2 billion US gallons 7,600,000 m. Of fuel each year. Extended tire life: Under inflated tires are the #1 cause of tire failure and contribute to tire disintegration, heat buildup, ply separation and sidewall/casing breakdowns. Further, a difference of 10 lbs. In pressure on a set of duals literally drags the lower pressured tire 13 feet per mile. Moreover, running a tire even briefly on inadequate pressure breaks down the casing and prevents the ability to retread. It is important to note that not all sudden tire failures are caused by under-inflation. Structural damages caused, for example, by hitting sharp curbs or potholes, can also lead to sudden tire failures, even a certain time after the damaging incident. These cannot be proactively detected by any TPMS. Decreased downtime and maintenance: Under-inflated tires lead to costly hours of downtime and maintenance. Improved safety: Under-inflated tires lead to tread separation and tire failure, resulting in 40,000 accidents, 33,000 injuries and over 650 deaths per year. Environmental efficiency: Under-inflated tires, as estimated by the Department of Transportation, release over 57.5 billion pounds of unnecessary carbon-monoxide pollutants into the atmosphere each year in the United States alone. 6 Good Reasons to Install a TPMS. When the tire is high or low, or high temperature, the system will send a trigger warning in time to reduce the puncture possibility. When the tire is leaking, the system will immediately send a trigger warning. It will accelerate tire wear when the tire pressure is too high or too low. Keep the tire pressure correct to extend tire life. Vehicle deviation will easily occur if tires are unbalanced. When the tire pressure is low, the fuel consumption will be increased due to the high rolling resistance of the tire. In 2007 the US government legislated the mandatory installation of TPMS to new vehicles. In 2012, 27 countries in the European Union plus Japan and Korea legistalted the mandatory installation of a TPMS to new vehicles. In 2016, China, Australia and several South East Asian countries will legislate the mandatory installation of TPMS to new vehicles. Working temperature: – 20 80. Storage temperature: – 30 85. The charger input voltage: DC 12 24 v. Frequency: 433.92 MHz. Operational Temperature: -40 to 80°C. Storage Temperature: -40 to 85°C. Pressure Range: 0 to 8BAR, 0116PSI. Pressure Accuracy: ±0.1BAR, ±1.5PSI. Transmission Frequency: 433.92MHz. Battery life: 2 years(CR1632, -40 to 80°C). Size: 21mm(diameter) x 21mm(height). Changing the Pressure Alarm Ranges. Our TP-09 and TP-10 TPMS Systems have an adjustable pressure alarm range however this is set to a minimum of 25PSI. Check with us if this has changed as we are constatly improving our products. To switch off the alarm noise if you are running below this then you can hold the TPMS button to disable the sound. For changing the alarm ranges please refer to the manual on page 4, 3-4 Parameter settings The Alarm needs to be set from the DVD interface of parameter setting. When the vehicle is in the DVD working mode, Press the SET button for 2 seconds to choose “High pressure pressure alert setting”, press SET button for 1 second to enter parameter setting, Press CODE button to save and exit setting mode. Sign Up For Our Newsletter. Upgrades for In Dash Systems. Off Road Map Data. Trak Racer Gaming Accessories. Vehicle Cameras Monitor Acces. Vehicle Dash Camera Recorder. In Dash Navigation Systems. The item “-TPMS Tyre Tire Pressure Monitor System 8 External Cap 22 Sensors DVD Video Cars” is in sale since Saturday, June 04, 2016. This item is in the category “Vehicle Parts & Accessories\Car, Truck Parts\Wheels, Tyres\Tyre Accessories”. The seller is “dig_options” and is located in Brunswick East. This item can be shipped worldwide.
- Manufacturer Part Number: Does Not Apply
- MPN: TP-10-8
- Brand: Masten
